Command and Processes Table - V

For more information on the terms 'Command', 'Process' and 'Macro Command', see Command Table Introduction.

Commands not supported by your product are listed here for contextual purposes only - detailed information about these commands is available from their respective product help files.

Note: if a command is included within your application, you can access more information using the associated link in the right-hand column.

Symbols used in this table:

	- A green tick indicates that the module is part of the core system licensing for the specified product - no additional module is required
X	- A red cross indicates the module is not part of the listed system and any commands held within it cannot be run (a separate product will be required)
�	- A blue diamond indicates the module is an optional extra for the specified system

Commands - V

Command Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
validate-onthefly-switch						X	X	Use a validation file opened with the open-validation-file command.
vein-from-samples		X	X	X	X	X	X	Create vein and vein-like continuous structures from a specified categorical sample attribute.
vertical-length-switch							X	Control whether the HLENGTH field in a blast patterns file is an actual or vertical length.
view-by-one-point								Set the 3D view position and orientation based on a selected point and orientation.	Command Help
view-by-three-points								Set the 3Dview position and orientation based on three selected points.	Command Help
view-by-two-points								Set the 3D view position and orientation based on two selected points and orientation.	Command Help
view-to-plot								Change the current Design view to that of a selected plot file (*.dm format).	Command Help
viewset								Opens the View Settings dialog to set the section definition and rotate the view interactively.	Command Help
vr-to-plot-create								Create a new plot sheet based on the contents of the active 3D window.	Command Help
vr-to-plot-overlays								Convert existing 3D window overlays to plot sheet overlays.	Command Help
vr-to-plot-section								Convert the current 3D view to a plot section.	Command Help
vr-to-plot-view								Convert the current 3D view to a Plot sheet projection.	Command Help

Processes - V

Process Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
VALIDA								Validates fields against each other in a Datamine file.	Process Help
VARFIT			X			X	X	The process allows you to display experimental variograms, as produced by the VGRAM process, and fit a model to them using interactive graphics.
VCONTOUR								The VCONTOUR process creates a variogram contour plot and displays it in the Design window.
VER								Displays the current Studio version and build number in the Command control bar, and optionally the version update history.	Process Help
VGM3DMAP		X	X	X	X	X	X	Interpolate experimental variogram values into a 3D map (represented by a block model).
VGRAM		X	X	X	X	X	X	This process calculates variograms and/or cross variograms for a range of azimuth and dip directions.

For Macro commands, see here.